Plumber and Electrician in New Port Richey, FL

The same Census survey counts 9,563 housing units in the city. About 2,591 were built in the 1970s and 2,926 in the 1980s, which together make up more than half the stock. Another 1,131 date to 1959 or earlier. Mobile homes account for 1,382 units in the city and 3,136 in ZIP 34653 alone.

That mix decides the work. A 1960s block house is likely to have galvanized supply pipe and cast iron drains. A 1970s ranch may still have its original panel, and some of them have aluminum branch wiring. A house plumbed between 1978 and the mid-1990s may have gray polybutylene. The newer subdivisions east toward Trinity mostly need water heaters, surge protection and the occasional added circuit.

A New Port Richey mailing address does not tell you who supplies your water. The City of New Port Richey states that its utility service area and its city limits are different maps, and Pasco County Utilities serves much of the surrounding unincorporated area. Your water bill shows which one you have.

The city's 2025 water quality report says its water comes from 10 wells in the Floridan Aquifer, treated at the William C. Maytum plant with aeration to strip hydrogen sulfide and chloramine for disinfection, with the Tampa Bay Water regional system as a backup source. The same report lists the 90th-percentile copper result from household taps at 1.273 ppm against an action level of 1.3, with three sampled homes over the line. Copper at the tap comes from corrosion inside household plumbing, so an older copper system on city water is worth watching for pinhole leaks and green staining at fixtures.

For city utility customers, the city puts the line at the meter. A leak between the house and the meter is yours to fix. A leak between the meter and the street goes to New Port Richey Public Works.

Galvanized steel pipe rusts from the inside until pressure drops and the water runs brown. Polybutylene was installed across Florida from roughly 1978 to 1995 and fails at the fittings and from chlorinated water attacking the pipe wall. Copper from the 1970s and 80s tends to pinhole. When leaks start showing up in more than one spot, a repipe usually costs less than chasing them one at a time.

We replace supply lines in PEX or copper, open the smallest wall sections we can, and pull the permit from the city or Pasco County depending on where the parcel sits. Slab leaks get located before anyone breaks concrete, and often the fix is a reroute through the attic or walls instead of a jackhammer.

Houses from the 1950s through the 70s usually have cast iron drains under the slab and an older lateral running to the street. Cast iron scales up inside and cracks along the bottom, and roots find any open joint. Recurring backups in the same fixture usually point to the line, and a camera inspection shows which.

Before you call anyone, look in the yard for the sewer cleanout, a white capped pipe near the house or the street. The city says customers on its sewer who have a cleanout and a backup should call Public Works first so they can check the city side. If the main is clear, the problem is on your side of the line and that is where we come in.

We install Rheem, A.O. Smith, Essency and GE tank water heaters and are an authorized installer for Optimal electric tankless units, which carry a 25-year residential warranty. A tank that is leaking at the base or has passed about 10 years is usually a replacement. A younger tank with a bad element, thermostat or valve is usually a repair.

For gas units, the Pasco Economic Development Council lists Clearwater Gas as the natural gas provider for southwest and south-central Pasco County, which covers a lot of New Port Richey. Houses without a gas line can go electric tank or electric tankless, and we check panel capacity first because a tankless unit draws heavily.

A 1970s house often still has its original panel, and in this part of Florida that sometimes means Federal Pacific Stab-Lok or Zinsco. Both brands have long-documented problems with breakers that fail to trip, and many insurers ask about them by name. Older services were also commonly 100 amps, which leaves little room for a heat pump, a pool pump, a hot tub or an EV charger.

Panel replacement includes a load calculation, new grounding and bonding where the old work falls short, the permit and inspection, and coordination with the power company for the disconnect and reconnect. The Pasco Economic Development Council lists Duke Energy as the main provider in southwest Pasco and Withlacoochee River Electric Cooperative in the north and central county, so check the name on your bill.

Solid aluminum branch wiring went into American houses from roughly 1965 to 1973, which overlaps a lot of New Port Richey's older stock. The wire is fine in the middle of a run. The trouble shows up at outlets, switches and splices, where aluminum expands, loosens and overheats. Warm cover plates, flickering lights and a hot plastic smell are the signs to act on.

The fix is approved connectors at every termination or rewiring the affected circuits. We also replace ungrounded two-prong outlets, add dedicated circuits for kitchens and window units, and run a safety inspection for buyers and insurers who want one.

A whole-house standby generator starts on its own and switches the house over through an automatic transfer switch. Natural gas units can tie into the Clearwater Gas line where it reaches the street. Houses without gas run on a propane tank.

A portable generator can also run the house safely through a generator inlet and a panel interlock or manual transfer switch. Plugging a generator into a dryer outlet with a double-male cord is dangerous for you and for line crews working on the street. Either setup needs a permit, and we size the generator to the loads you want running, usually the refrigerator, the well or sewer lift if you have one, lights, fans and at least one air conditioner.

The National Fire Protection Association recommends replacing smoke alarms 10 years after the date printed on the back. Older houses often have a mix of hardwired and battery units of different ages, and some have no alarm in the bedrooms at all.

We install hardwired, interconnected smoke alarms with battery backup so one alarm sounds them all, add combination smoke and carbon monoxide units where there is gas or an attached garage, and replace aging hardwired units with compatible models so the interconnect keeps working.

GFCI protection shuts off a circuit when current leaks to ground, which is what happens when water and electricity meet. Current code requires it in bathrooms, kitchens, laundry areas, garages, outdoors and near pools and hot tubs. Houses built before those rules often have none, or have one outlet that protects others downstream with nobody sure which one.

A GFCI that trips and will not reset usually means a real fault on the circuit, often water in an outdoor box or a failing appliance. We find the cause before swapping the device, and we can add GFCI breakers at the panel when outlet-style units will not fit.

A hot tub needs a dedicated 240 volt circuit sized to the manufacturer's nameplate, GFCI protection, and a disconnect within sight of the tub and at least 5 feet from its inside wall. Pools also need equipotential bonding, a copper grid tying the pool shell, deck and metal parts together so they sit at the same voltage. Bonding is easy to damage during resurfacing or deck work and hard to see afterward.

We wire new hot tub installs, replace corroded disconnects and pump circuits, troubleshoot tubs that keep tripping the GFCI, and check bonding on older pools. Spa and pool electrical work goes through a permit and inspection, from the city or the county depending on the parcel.

During Hurricane Helene on September 26, 2024, the National Weather Service recorded a peak water level of 5.04 feet above mean higher high water at the New Port Richey gauge before it stopped reporting. Idalia the year before had already flooded homes along the Pasco coast. Saltwater ruins breakers, outlets, water heater controls and gas valves even after the water drains, so any of those that sat in surge get replaced.

Inside city limits, New Port Richey applies the federal 50 percent rule. If repair or improvement costs reach half the structure's market value, the building has to meet current flood rules, which can mean elevating it. The city's substantial damage packet counts electrical and plumbing repair, light fixtures, built-in appliances and water treatment systems toward that total, and it requires electrical and mechanical equipment to sit at or above the 100-year flood elevation on a substantially damaged house. Ask the building division how your project scores before you schedule it.

The City of New Port Richey runs its own Building Division at City Hall, 5919 Main Street, and it permits work only inside city limits. Addresses outside the city go through Pasco County Building Construction Services. The city's own guidance is to check the Pasco County Property Appraiser site to see which side of the line your parcel is on. The city uses Pasco County's contractor registration, so one registration covers both.

Titan works in New Port Richey Monday through Saturday, 24 hours a day, and is closed Sunday. Same-day visits depend on the schedule, and every job gets a flat-rate price before work starts. Call (813) 933-8010.